Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Set the Offset as described above
  2. Press Continuous AF in the ZDC Control panel
  3. The ZDC locks onto the AF plane, but this won't necessarily be the plane you are interested in
  4. Scan your specimen with Continuous AF on
  5. Press the Continuous AF tab on the I3-TPC touch pad controller
  6. The yellow line (red arrow below) indicates the position of the Focus Limit
    Image Added
  7. Press the Fine button on the controller to activate the fine focus
  8. Adjust the focus until the plane of interest is in focus
  9. Press the Fine button again to reactivate the Continuous AF at this new position
  10. Start your imaging (AF status will show “Focussing” throughout the entire image acquisition)

...