How to correct for chromatic shift using Volocity

...

It might be necessary to correct for chromatic shift in images and stacks if you are acquiring data for colocalisation analysis. Volocity can ; particularly when using the Leica SPE confocal. Volocitysoftware can be used to generate Registration Corrections that can be applied to 3D data to shift pixels in all channels back to their correct positions.

...

Use a suitable specimen to create a registration correction. I use a slide of 0.5 micron multicolour TetraSpeck beads from Molecular Probes because they are small, bright and are labelled with blue, green, red and far red fluorophores. It makes sense to acquire the beads during the same session as the specimens you will want to correct. Capture 3D stacks of these beads at the same XY and Z resolution you will be acquiring your data at so that the pixel shift is correct. You don't need to worry about whether the laser power, gain and offset are the same as for the specimen - just so long as you avoid saturation in the bead images.

The procedures for creating and using Registration Corrections are in the Volocity manual. Please see the following pages.

• Volocity page 95 – Creating Registration Corrections
• Volocity page 98 – Correcting Registration

Use the automatic correction. The ; the manual correction is a bit buggy but the automatic correction always works well.The LMCB

Light Microscopy Facility will be creating and storing bead data and registration corrections acquired using a range of objective lenses on different microscopes. These will routinely be captured at the highest resolutions possible for the objectives so if you want to use these previously prepared corrections you should capture your data at the same resolutions.If you have any more questions about chromatic shift correction then please email the Light Microscopy Facility: lmcb-lm-help@ucl.ac.uk