...
- A fixed-stage upright DM6 microscope stand
- The choice of standard objective lenses and special long-working distance dipping lenses for imaging deep into live and cleared specimens
- A dual-beam Coherent Discovery multiphoton laser with a tunable laser line and a fixed 1040 nm laser line
- A range of visible lasers for confocal imaging
- Spectrally tuneable imaging with non-descanned detectors using the 4Tune system.
Technical Specifications
...
Standard objective lenses
The objective lenses in the table below are installed in non-adjacent positions in the standard 6-position nosepiece for objective lenses with M25 threads. Objective lenses are not installed in all positions to prevent damage to adjacent lenses as theĀ the objective lens is focused.
...
There is also a 10x HC PL APO CS2 0.4 NA (P/N 506424) air lens that can be installed in the standard nosepiece if required.
Specialised objective lenses
The objective lenses below have a larger M32 thread. To install these lenses the standard nosepiece must be removed from the microscope and replaced with a single-position nosepiece. Hence only one of these lenses can be installed at any one time. They have motorised correction collars which can be adjusted from within the software to correct for refractive index mismatches.
Magnification | Type | NA | Immersion | WD | Part Number |
---|---|---|---|---|---|
25x | HC IRAPO L motCORR | 1.0 | Water dipping | 2.6 | 507704 |
25x | HC FLUOTAR L motCORR VISIR | 1.0 | Clarity | 6 | 507703 |
Note that the 6 mm working distance of the Clarity lens will mean that any sample imaged using this lens will most likely have to be mounted in a deep vessel.